RADIANCE / FIELD GUIDE

Connect. Check. Decode.

Get one receive path working first. Then verify the waterfall, decoded text and reviewed contact before calling the test successful.

RECEIVE ONLY / CURRENT CHROME OR EDGE

1. Choose a receive path.

  1. Connect the radio’s USB receive audio or a compatible audio interface. Confirm your operating system sees the input. Start at a low level and tune a clear CW signal on the radio.
  2. Open Connect my radio in the invited trial. Select My radio · USB / audio input for generic receiver audio.
  3. Press Refresh inputs, allow audio permission, then choose your receiver or interface by its actual device name. Browser “microphone” permission also covers USB audio inputs.
  4. Press Start receive. Check that the receive meter responds and the waterfall changes with your radio’s audio. Use Hide radio setup to bring the instruments into view.

For IC-705 read-only status or RTL-SDR, choose the corresponding Companion path instead. Start Mac Companion, paste its current pairing code, pair, choose the detected device and then start receive. CI-V status alone does not carry receive audio.

2. Follow one clear signal.

In Receive settings, enter the approximate starting WPM. A clear tone around 500–800 Hz is a useful first test. Automatic tone tracking follows a strong signal; disable it and select the intended waterfall trace if a neighbouring station pulls it away.

Set the receiver/interface level so the meter responds without clipping. Compare the transcript with what you hear. Reception, audio permission and a moving waterfall do not by themselves prove correct decoding.

3. Save and review the contact.

Enter callsign, report, band and UTC in Logging, then choose Save note. Review the suggested fields and select Confirm contact. Live contacts require your review; they are not automatically created by the decoder.

Use Export notes & contacts to keep a backup. These notes and contacts are local to the browser. Press Stop after the test and verify that reception stops.

If setup stalls.

  • No input: check the OS device list, reconnect, refresh and allow this site’s audio permission.
  • No Companion connection: restart it, use the current code and allow local-network access when prompted. Generic receiver audio can still work without CAT status.
  • Waterfall but no useful text: check a single CW tone, WPM and input level, then try a known recording.
No transmission or PTT is enabled by this trial. Never connect RF or speaker-power output to an audio input. Keep IC-705 USB SEND and USB keying off.